AVG Hot Water Pressure & Temperature Relief Valve 15mm 1400KPA Extended Body

(No reviews yet) Write a Review
SKU:
PTRE15-1400AV
Weight:
0.50 KGS
Shipping:
Free Shipping
  • AVG Hot Water Pressure & Temperature Relief Valve 15mm 1400KPA Extended Body
  • AVG Hot Water Pressure & Temperature Relief Valve 15mm 1400KPA Extended Body - Insulation Boot
  • AVG Hot Water Pressure & Temperature Relief Valve 15mm 1400KPA Extended Body - Dimensions
  • AVG Hot Water Pressure & Temperature Relief Valve 15mm 1400KPA Extended Body - Rating
  • AVG Hot Water Pressure & Temperature Relief Valve 15mm 1400KPA Extended Body - Spec
  • AVG Hot Water Pressure & Temperature Relief Valve 15mm 1400KPA Extended Body at plumbonline
$88.00

Description

AVG PRESSURE & TEMP RELIEF VALVE 15mm 1400KPA Extended Body

What do you get?

  • AVG Hot Water Pressure & Temperature Relief Valve
  • Extended Body
  • 15mm 1400KPA
  • plumbonline's rapid order turnaround, even for late afternoon orders
  • FREE delivery to your door

PTR Valve Function
The Pressure and Temperature Relief valve (PTR) is designed to relieve the increase in pressure caused by water expansion during the normal heating cycle. The valve will then relieve the increase in pressure by releasing drips of hot water to the drain line. Should the electrical temperature cut-out device cease to operate correctly, the water will overheat.

The temperature probe will then open the PTR valve and discharge hot water to the drain line. It is recommended that an ECV be fitted to the cold water supply line. This will relieve cold water, not hot water, during the heating cycle, saving energy and increasing the life of the PTR. Some local governments make it mandatory to install an ECV in the cold water line. PTR and ECV valves are safety valves and should be replaced every four years.

Inlet Pressure Control
High pressure may cause excessive discharge and possible premature failure of the operating relief valve (see table). The maximum water pressure usually occurs during the night, at the time of lowest water usage.

In any mains pressure water heater installation, if the water pressure exceeds 80% of the nominal set pressure of the operating relief valve, a Pressure Limiting Valve must be fitted to the cold inlet. If a cold water expansion control valve is fitted it will have a lower set pressure than the PTR valve and therefore will be the main operating relief valve.

The valve rating plates are colour coded to make selecting the correct valve easy. Simply match the PTR valve to an ECV with a rating plate of the same colour.

View AllClose

0 Reviews

View AllClose